PLC & Control Systems
- Siemens S7 diagnostics
- TIA Portal support
- PLC logic investigation
- HMI and operator feedback checks
- I/O signal verification
- Startup sequence checks
Industrial Networks
- PROFINET diagnostics
- PROFIBUS diagnostics
- CAN and CAN FD communication checks
- CANape integration support
- Signal plausibility review
- Communication fault isolation
Safety & Interlocks
- Safety relay checks
- Safety interlock validation
- E-stop chain verification
- Gate and guard monitoring
- Safe operating mode checks
- Manual mode safety logic review
When this service is needed
This service is useful when automation faults block test execution, safety circuits prevent startup, PLC communication is unstable, drives do not respond correctly, or operators need a safer and clearer control interface during commissioning or validation.
Drive & Actuator Support
- Bosch Rexroth IndraDrive support
- Drive fault investigation
- Actuator response checks
- Motion readiness verification
- Feedback and command signal checks
Signal & DAQ Integration
- Sensor signal verification
- DAQ readiness checks
- Measurement chain validation
- CANape signal mapping support
- Alarm and monitoring logic checks
Clear Deliverables
- Automation diagnostic notes
- I/O and signal checklists
- Safety-chain observations
- Drive and communication findings
- Recommendations for stable operation
Control systems must be safe, understandable and test-ready
In complex validation environments, automation and safety cannot be treated separately. PLC logic, drives, interlocks, E-stop systems, operator commands and measurement software must all agree before reliable testing is possible. InnovaDrive helps connect these layers into a controlled and traceable operating state.
Need automation, PLC or safety support?
InnovaDrive supports diagnostics, startup checks, safety-chain verification and automation recovery across industrial test bench environments.
Request Automation Support